Easy DIY plant propagation stations! Krazy Craft glue #ad is perfect for small DIYs like this because not only does it dry fast, and smell good, but the Craft Glue features Skin Guard™ formula with delayed skin bonding which is perfect for projects where you need maximum control and time for adjustments. Supplies: One bottle of Krazy Craft Super Glue One 1/2x2”-4’ piece of poplar or any 2” wide board Spray paint or stain Clear test tubes (link in our Amazon storefront) Any size mitre saw with a fine tooth blade 7/8 in. forstner bit for holes Drill Masking tape Instructions: Set blade to 30 degrees, cut six 6” equal pieces to form a hexagon. -Lay pieces out end to end on a strip of masking tape - add Krazy Craft glue to the joints and form the hexagon. Set aside to dry. -Take left over piece of wood and cut the remaining ends at a 30 degree angle so that strip fits in the middle of the hexagon piece (approximately 10 3/4” in length) -Drill two or more holes with a 7/8” forstner bit, centered in the middle board to hold the test tubes -Paint or stain to liking #krazyGlueIt #ad @Krazy Glue ##howto #tutorial #plant #propogation #propogationstation #planttiktok #plantmama #diyproject #asmr #asmrsounds