Alright so you have one of these but this will save you time- let me show you So previously I made this jig to perfectly drill pocket holes in the center of the narrow side of a 2x4. And that went over pretty well! Then a handful of comments said to make a jig for the 4x side of A 2X4, so I did! And this is what I came up with. it perfectly offset the jigs from the end of the 2x4 and they are spaced 2” apart. Without this jig, drilling two holes like this would take 34 seconds. But with this jig, drilling two hole only take 12 seconds, saving you 22 seconds for each pair of holes like this. But maybe you only want one hole centered on the 4” side of a 2x4 - well, I made a jig for that as well! All of these jigs accept the keg jig mini, and are friction fit in place so its as easy as popping the KJM in place and drilling away! And if you want one of these jigs, be sure to check out my TikTok shop! #kregjig #3Dprinted #tiktokshop #woodworking #pocketholes #jig #woodworkingjig #woodworkingproject #woodworkingtools #woodworkingcommunity #3dprinting #bambulab #3dprinted #wideside @BAMBULAB USA @Doing Whatever